Journal: BJM Open
Rehman U, Colton D, Gupta S, et alUse of 3D printed head and neck models for simulating 10 common ENT emergency procedures: a prospective validation studyBMJ Open 2025;15:e095877. doi: 10.1136/bmjopen-2024-095877
Objective
This study aims to validate a high-fidelity three-dimensional (3D)-printed head and neck model for training emergency medicine (EM) physicians, primary care physicians and allied health professionals in managing 10 common ear, nose and throat (ENT) emergencies.
Setting
The study was conducted at an ENT Emergencies course in London.
Study design
Prospective validation study.
Participants
All delegates (n=90) were healthcare professionals. Among them, 60% (n=54) were EM residents/trainees, 28% (n=25) were primary care residents/trainees, 4% (n=4) were ENT residents/trainees, 4% (n=4) were emergency nurse practitioners, 2% (n=2) were primary care attending physicians and 1% (n=1) was an EM attending/consultant. All faculty were consultant ENT surgeons (n=11).
Intervention
The 3D models, produced using proprietary 3D printing technology (Fuesetec), were used in a 1-day ENT emergencies course for validating training and confidence of delegates in performing 10 common ENT emergencies.
Results
A total of 86% (n=77) of delegates found the models extremely or very helpful in learning ENT emergencies. Delegates rated the resemblance to real patients as excellent or very good in both haptic feedback (n=58, 64%) and tissue texture (n=67, 74%). Additionally, 74%–96% of delegates felt confident in performing the 10 ENT procedures after using the models.
Conclusions
The 3D models enhanced participant confidence in performing 10 common ENT emergency procedures, demonstrating good face, content and indirect criterion validity. These models could support emergency ENT skill development in local emergency departments.